更新時間：2018.07.20

Angle seat valve keep velocity can save a space. It USES a single function pneumatic actuators with spring security to manipulate the steering Angle seat valve. When using, should choose the normally open or normally closed. Angle seat valve is widely used in a short period of time frequently, responsive, characteristics of action accurate, used with magnetic valve, using pneumatic control can accurately control the gas and liquid flow. Can achieve accurate temperature control, drip and liquid requirements. The corner valve is used in the wet and hot sterilizer to control the temperature accurately. The product is made of stainless steel casting and polytetrafluoroethylene. It can be used in most gas, liquid, steam and corrosive situations. How it works; According to the function of spring reset to open and close, it can be divided into normally open type and normally closed type. Double acting (pneumatic head is usually two holes); How it works: the air supply controls its switch. (according to the customer's requirements, you can also choose double action plus spring reset for more accurate control) how to install the stainless steel pneumatic angular set valve? Installation and maintenance must comply with applicable safety specification 1. Pipes must be clean and pollution-free. 2. Install as needed, but it is best to keep the actuator up. Notice the direction. 3. Be careful to align the valve with the pipe and remove the actuator only when the user specifically requires it. 4. Before opening or repairing the Angle valve, cut off the fluid, control the air source and reduce the pressure in the piping system. Note: characteristics of flow direction A: 1. When choosing the flow direction, the service life of the product can be improved. 2. When the working medium is liquid, select the direction of the water-resistant hammer impact.